APPARENTLY, it is used in the 2001 XR200's transmission, but few places seem to carry that part for whatever reason. The output shaft seal was a little more tricky. These should be easy enough to come by though. The crank bearing is a 62/28 (28x58x16) and I believe they use this one in many of their 4x4 wheel bearing assemblies although I'm not sure about the shield configurations. Turns out those lazy (Smart?) guys over at Honda use the same seals for the water pump, kickstart, and shift shaft as they do in their CR125! The water pump bearing is a standard 16001 (12x28x7) and is also used as the water pump bearing in the CR250. Jim Sandiford has the crank seals, and the water side water pump seal, but I couldn't find any of the others. ![]() ![]() I was looking for oil seals and going crazy trying to find the right ones online. I thought I'd share the fruits of a couple of hours of research I did.
0 Comments
Leave a Reply. |